Stock Car Racing Homepage
 

The Chevy Beretta - So Close to Cup

Dashed dreams of becoming a star.
Photography by Mike Slade
Chevrolet Beretta Race Car Front Drivers Side View Close Up
Chevrolet Beretta Race Car Front Drivers Side View
Chevrolet Beretta Race Car Engine Bay View
A Chevy small-block powered the Beretta.
Chevrolet Beretta Race Car Interior View Drivers Side
The Beretta cockpit was outfitted like any other Winston Cup ride.

It was the late ’80s when the Monte Carlo was dropped from the product line of Chevrolet, creating the problem of what to race in NASCAR. Rumors abounded that the new Chevy Lumina was waiting in the wings, but it was not in production yet, thereby voiding the rules.

Thus began an almost frantic search for a suitable bridge between the Monte Carlo and the Lumina—and all eyes focused on the Beretta. The Beretta was then available as a production model and would have fit NASCAR and ARCA criteria.

Size Does Matter

While NASCAR watched with more than a passing interest, ARCA approved the Beretta. But recall that the Beretta was noticeably smaller than the Monte Carlo and Thunderbird. Norman Negre accomplished the initial Beretta buildup for owner Jim Coyle. To meet the ARCA specs, which are practically identical to Winston Cup, the Beretta wheelbase had to be stretched a 10 inches. The car’s width was increased by about 8 inches by fabricating new fenders and quarter-panels. The lengthened and widened racer gained a completely different look from its street brothers.

The new, GM-sponsored Beretta car ran the final ’87 ARCA race at Atlanta with Lee Raymond at the wheel. The car was a screamer with a new track record and a strong Second-Place finish. Some people had the feeling that the car could have easily won its debut but was held back. The following season, again at Atlanta, the Riverside Auto Parts Beretta also won a second. The car also took two wins at Pocono and another second at Atlanta. In the final race of the season—at Atlanta—the car was involved in a heavy crash, tearing it in half. Lee was OK, but the Beretta was a goner.

Raymond, an ARCA Champ, recalls, “The car got a ton of publicity, and there wasn’t much bitching from the other drivers because of its dominance. The Winston Cup teams were interested in the car, and we got a lot of advice from Junior Johnson, Tim Brewer, and Richard Childress. The car was really fast. During testing for the ’87 Atlanta race, I remember we were turning laps at about 172 mph, while some Winston Cup teams were in the high 160s. That car drove like a rocket ship. I loved to drive it.”

One fault Raymond noticed, however, was that the car always seemed very loose at speed—maybe because of its short rear section. “It didn’t have much downforce, with most of the air blowing right over the top of the rear spoiler. But it was really sleek and had a coefficient of drag about half that of a Monte Carlo.”

NASCAR decided, though, that they would not allow the modified Beretta to participate in Winston Cup. Instead, the old Monte Carlos were used until the Lumina was ready. Even then, the two-door Lumina was on the racetrack before it was on the street.

Maybe the Beretta was just too good. Lee Raymond and Jim Coyle certainly demonstrated that in the Beretta’s short career!


Discuss in Our Forums
Volkswagen Eos Research
Volkswagen Eos Get updated on all your car buying needs from safety features, to specs, to crash test ratings and options. Get all the information you need if you are interested in buying a new car like the Volkswagen Eos. The L4 standard engine in the Eos gives you 200 horsepower with an estimated 26 mpg. It can seat 4 people comfortably. Also check out the Dodge Charger and the Dodge Avenger.
•  
Nascar Driver - Robby Gordon - His Own Man
Talented. Passionate. Stubborn. Say What You Want About Robby Gordon, But A Burning Desire To Race Is His Defining Trait... more
•  
•  
2007 Rumble in Fort Wayne - Rumblin' Along
The Rumble in Fort Wayne has built quite a tradition in its 10-year history... more
•  
Affordable Racing Tools - Must-Have Tools
A list of vital racing tools to beef up your toolbox on a budget... more
•  
Young Racers' Club August 2008 - Zach Reining
This month's lucky YRC Winner is Zach Reining from Forreston, Illinois... more
•  
Rear Axle Movement - Roll Steer And Its Effects
We examine roll steer and explain how it can impact your stock car... more
•  
Young Racers Club Winner June 2008 - Cody Swanson
Read about Cody Swanson, the June 2008 Young Racers Club winner... more
•  
Mini-Stock Racing - Go-Fast Tips For Mini-Stocks
These engine and chassis tips for Mini-Stock racers will help point the way to Victory Lane... more
•  
Ryan Newman lifts Penske Racing to new level
Ryan Newman took the lead on the last lap and never looked back as team mate Kurt Busch pushed him to victory in the 50th Daytona 500... more
•  
500 HP Racing Engine For $2,500 - Is It Possible?
We're out to prove that an engine doesn't have to perform cheap because you buy cheap. We build a dyno-ready 506hp engine on a $2,500 budget... more